ABOUT US | CERTIFICATIONS | CATALOG | CONTACT US | REQUEST QUOTE
 
 
  Translate This Page 
 

Catalog

Products

Product Flyers

Aztec News

Who's Who

Green

Install Videos
 

Universal Retrofit Master Flash®

The Universal Retrofit has been designed to accommodate existing applications where a standard pull over flashing cannot be installed. The split design allows an easy wrap around fit with a single stainless steel clamp for sealing.

Check diameter of your pipe or duct and select appropriate Universal Retrofit Master Flash® to accommodate your application as indicated on the chart below. For extreme pitch or surface irregularity, select next larger size. Simply split the flashing at the designated area and close with the stainless steel clamp as instructed on the installation instructions.
 

UNIVERSAL RETROFIT MASTER FLASH®

WEATHER PROTECTION

Made of EPDM or Silicone, these flashings are compounded specifically formaximum resistance to weathering due to ozone and ultraviolet light.

EASY ON-SITE CUSTOMIZATION

Fast, one piece construction allows for easy on-site installation in usually 5 min.

AVAILABLE IN BLACK OR GREY

FLEXIBLE BASE

Easily forms to contours of roof panel.


 
ADVANCED OZONE RESISTANCE tested to...

EPDM
70 hours @ 500 pphm

SILICONE
70 hours @ 500 pphm
HIGH TEMPERATURE RESISTANCE
Tested to Intermittent
  Continuous
 
+135ºC (+275ºF)
+100ºC (+212ºF)
 
+260ºC (+500ºF)
+225ºC (+437ºF)
LOW TEMPERATURE RESISTANCE tested to...
-55ºC (-67ºF)
-74ºC (-101ºF)
COMPRESSION SET minimum... 25% 50%
 

Sizing Chart

Designate Pipe Size Compound Part No. Flashing Details
#1
 3/4" - 2-3/4" Black EPDM RF101BS-RD Top Opening diameter    3/4" (19.1 - 69.6mm)
(19.1mm - 69.6mm) Grey EPDM RF101GS-RD Cut to suit pipe size       3/4" - 2-3/4" (19.1 - 69.6mm)
  Red Silicone RF101RS-RD Base Dimensions           4-3/4" (120.7mm)
#2
 2" - 7-1/4" Black EPDM RF201BS-RD Top Opening diameter    2" (50.8mm)
(50.8mm - 184.2mm) Grey EPDM RF201GS-RD Cut to suit pipe size       2" - 7-1/4" (50.8-184.2mm)
  Red Silicone RF201RS-RD Base Dimensions          10-3/4" (273.1mm)
#3
 3-1/4" - 10" Black EPDM RF301BS-RD Top Opening diameter    3-1/4" (50.8mm)
(82.5mm - 253.9mm) Grey EPDM RF301GS-RD Cut to suit pipe size       3-1/4" - 10”(50.8mm-253.9mm)
    Red Silicone RF301RS-RD Base Dimensions           14-1/2" (641.4mm)

Flashing Detail

 

   
   
   
 
 
 
13821 Danielson St., Poway, California 92064 | 1-800-WASHER 5 (927-4375) | 1-858-513-4350 | Fax 1-858-513-4305

Master Flash®, Universal Master Flash®, Universal Retrofit Master Flash®, Retrofit Master Flash®, Residential Master Flash®,
Square Vent Retrofit Master Flash®, Master Seal® and Master Plug® are registered trademarks of Aztec Washer Company, Inc.
©2009 Aztec Washer Company, Inc. | | Site Map | Privacy Statement